Filter
Top Products
PLACEMENT
PLACEMENT
Before you install the STUDIO 2 into your system, we recommend
that you follow these guidelines in choosing the location. This will
facilitate a clean, trouble-free installation.
1. Although well shielded, the STUDIO 2 should not be placed in
close proximity to hum-sensitive components (i.e. preamps,
turntables, tuners, etc.) that can create interference and induce
hum.
2. As with any high quality component, ensure that the vent
openings in the chassis are free from obstruction, allowing the
Processor to dissipate heat created by its power supply and Class
A output stage. Place the unit on a clean, level surface away from
excessive dirt or moisture. Make sure the STUDIO 2 has at least
2 inches of clearance on either side and 2-3 inches of space at the
top. Components that are heat sensitive should not sit directly
above the unit.
3. The STUDIO 2 does not require additional mass coupling or
isolation. You may experiment with feet or cones as long as they
do not permanently affix to the chassis. Any unauthorized
modifications to the electronics or chassis will void the warranty.
PAGE 5