Filter
Top Products
CONNECTIONS
INPUT AND OUTPUT CONNECTIONS
CAUTION: When making connections to this component or any
other, make sure the power amplifier is OFF and the preamplifier
is in the MUTE or STANDBY mode.
1. Connect the power cord to the back of the STUDIO 2 and plug
the unit into the wall AC receptacle.
2. Connect the STUDIO 2 analog output to the line level input of
your preamplifier.
The STUDIO 2 is equipped with two analog output configurations:
Single-ended via RCA connectors and balanced via XLR connec-
tors. If your preamplifier has high level balanced inputs, we
recommend the balanced outputs of the Processor be used. There
are considerable sonic benefits associated with the use of balanced
interconnection.
The XLR pin configuration is described below.
Pin 1
Pin 2
Pin 3
Ground
Non-inverting (0
°)
Inverting ( 180
°)
NOTE: The two outputs can be used to simultaneously feed
different systems.
NOTE: If you decide to use the single-ended analog outputs, the
type of interconnect cable should be chosen carefully. High
quality shielded cable is suggested.
PAGE 7