KVH Industries TracVision S3 Satellite TV System User Manual


 
The satellites listed in TracVision L3/S3’s satellite library will be
sufficient for most users. However, if you wish to install one or
two user-defined satellites, proceed to Section 2.5.2, “Programming
User-defined Satellites.” After configuring the user-defined
satellites, return to the satellite installation process in
Section 2.5.1, “Installing Your Selected Satellites.”
2.5.1 Installing Your Selected Satellites
When you first connect to the system, it is programmed with the
factory default satellite assignments:
Europe: Astra 1 (Sat. A) and Hotbird (Sat. B)
N. America (US DIRECTV): DSS_101 (Sat. A)
and DSS_119 (Sat. B)
N. America (US DISH Network): Echo_119 (Sat. A)
and None (Sat. B)
N. America (ExpressVu): Expressvu (Sat. A)
and None (Sat. B)
Should you wish to track a different satellite (either from the
satellite library or a user-defined satellite), you must instruct the
antenna which satellites will be in the active satellite pair.
Connecting to the TracVision L3/S3 Maintenance Port
To do so, it is necessary to connect a PC to the terminal
maintenance port on the switchplate. The diagnostics procedure
requires terminal emulation software such as PROCOMM or
Windows Terminal or Hyperterminal. Use the settings
appropriate to your application.
1. Connect one end of the PC data cable to the DB9
connector on the switchplate. Connect the other
end to the serial port on the PC (a 9-pin/25-pin
connector adapter may be needed for some PCs).
2. Open the terminal emulation software and
establish the following settings:
•9600 baud
no parity
•8 data bits
•1 start bit
•1 stop bit
no flow control
2-17
Installation
54-0157 Rev. G
The satellite configuration on
your IRD must match the satellite
setting on the TracVision L3/S3
system.
Satellite A on the TracVision L3/S3
must be the same satellite as IRD
Alternative 1 (or A, based on your
IRD) and must be assigned the IRD
DiSEqC 1 setting.*
Satellite B on the TracVision L3/S3
must be the same satellite as IRD
Alternative 2 (or B, based on your
IRD) and must be assigned the IRD
DiSEqC 2 setting.*
Refer to your IRD user manual for
complete instructions for your IRD.
* DiSEqC settings apply only to European
systems.
To receive DISH 500 service, you
will need to install the following two
satellites:
Echo_119 & Echo_110