Filter
Top Products
3. Apply power to the TracVision L3/S3 system and
allow the system to complete full initialization.
Data should be scrolling on the PC display to
identify any system problems detected. If no data
is seen, recheck your connections and the terminal
software setup.
Installing the Satellite of Choice
Once the data connection has been made between the PC and the
TracVision L3/S3, you must assign the satellites you wish to have
in the satellite pair. On the maintenance screen, put the antenna
in Idle Mode by typing HALT, then enter the SATINSTALL
command:
Command: SATINSTALL,<sat_a_name>,<sat_b_name><cr>
(<cr> indicates a carriage return/ENTER key)
Where: <sat_a_name> = the name of your choice for
Satellite A
<sat_b_name> = the name of your choice for
Satellite B
Table 2-5 lists the assigned names for satellites that are in the
preprogrammed North American and European satellite library.
If you do not wish to assign a pair of satellites, enter
None as the
name of Satellite B.
After you have assigned satellites as Satellites A and B, the final
step is to tell the antenna which of the two satellites it should
acquire and track. This step should be carried out the first time a
satellite is selected, allowing the system to carry out the initial
download of the channel guide. To do so, enter the Satellite
Selection parser command as follows:
Command: @L,x<cr>
Where: x = A or B (one of your selected satellites as
defined during the SATINSTALL process)
Choosing A or B will assign the antenna to acquire and track that
installed satellite. To complete the process, type
ZAP<cr> to
restart the system. Be sure the IRD satellite configuration matches
your chosen TracVision L3/S3 settings.
2-18
A Guide to TracVision L3/S3
Satellite Install Name
North American Satellites
DSS 101ºW DSS_101
DSS 119ºW DSS_119
EchoStar 61ºW Echo_61
EchoStar 110ºW Echo_110
EchoStar 119ºW Echo_119
EchoStar 148ºW Echo_148
ExpressVu Expressvu
European Satellites
ASTRA1 19.2ºE ASTRA1
ASTRA2N 28.2ºE ASTRA2N
ASTRA2S 28.2ºE ASTRA2S
Hispasat 30.0ºW HISPASAT
Hotbird 13.0ºEHOTBIRD
Sirius 5.0ºE SIRIUS
Thor 0.8ºW THOR
Other Installation Designations
User-defined 1 USER1*
User-defined 2 USER2*
None None
* USER1 and USER2 will only be
available if one or two user-defined
satellites have been added to the
library as detailed in Section 2.5.2,
“Programming User-defined Satellites.”
Table 2-5
Satellite Installation Names