Filter
Top Products
3. Connect the analog signal cable to the D-SUB connector of the monitor and the
other end on the back of the computer.
4. Plug the monitor power cord and the computer cord into grounded electrical outlets.
Note: A certified power supply cord has to be used with this equipment. The relevant
national installation and/or equipment regulations shall be considered. A certified
power supply cord not lighter than ordinary polyvinyl chloride flexible cord
according to IEC 60227 (designation H05VV-F 3G 0.75mm² or H05VVH2-F2 3G
0.75mm²) shall be used. Alternative a flexible cord be of synthetic rubber according
to IEC 60245 (designation H05RR-F 3G 0.75mm²) shall be used.
Chapter 1. Getting started 1-5