Filter
Top Products
32
206-4177
FTG Mode of Operation (Cont.)
Optional Manual Confi guration / Setup for a TV
Typical TV Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Run Auto Tuning and edit the channel
lineup, as necessary.
CHANNEL
Enter
Move
Auto Tuning
Manual Tuning
Channel Edit
Channel Label
Adjust the settings for these
Installer Menu items.
117 FACT DEFAULT 001
003 BAND/AFC 00X
xxLD310H PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC 20E7
PTC V1.00.001 CPU V3.25.00
Set Installer Menu Items
These steps provide speci c instruction only on the Installer Menu items
that should be set on an LD310H TV. Refer to pages 14 to 20 for detailed
information on all Installer Menu items.
1. Make sure the TV is ON. Then, use the Installer Remote to enter the TV
Installer Menu: Press MENU repeatedly until the on-screen setup menus
lock up, and then press 9-8-7-6 + ENTER.
2. Set Installer Menu item 117 FACT DEFAULT to 001 and press ENTER
on the Installer Remote.
This clears all Installer Menu custom settings, the channel lineup, etc.
and reloads the factory default settings. The value will change back to 0
after the internal TV controller (PTC) has been restored to factory default
condition. This step ensures that the TV Channel Memory will be the
active channel lineup.
3. Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 000. • HRC: Set to 002.
• CATV: Set to 001 (default). • IRC: Set to 003.
4. Set any other Installer Menu items that affect your TV programming
network to the required con guration. For example, enable/disable Aux
sources, set a Start Channel, etc.
5. After you have adjusted all required Installer Menu item settings, press
ENTER once on the Installer Remote to save your changes; then, press
ENTER again to exit the menu.
Run Auto Tuning (Channel Search)
Note: In the FMA Con guration le, Logical Channel numbers will automati-
cally be assigned in ascending order, starting with 0 (zero), to the Physical
Channels from the TV Channel Map.
Note: Pro:Idiom decryption for encrypted channels will not be enabled unless
you use the FTG Con guration Application to set the channel attributes.
1. Search for all available analog and digital channels: Use the Installer
Remote to go to the Channel Menu, select the Auto Tuning option, and
follow the on-screen instructions.
2. Use the Channel Edit option in the Channel Menu to edit the channel
lineup, as necessary, to include free to guest channels only. Add/delete
channels per your system requirements. Note that physical channel num-
bers are used to identify virtual channels. Also, channel numbers cannot
be higher than 255.
The manual configuration procedures below should only be performed if you do not know the RF channels
at the site and need to Learn the FMA Configuration file from an LD310H TV.