Filter
Top Products
38
206-4232
Teach Master TV Setup to Target TV
1. Turn ON the Target TV.
The next step depends on whether the EZ-Manager Wizard appears on the
screen:
• If the wizard is displayed, the TV is in the required factory default state. If
desired, you can complete the Teaching process via the EZ-Manager Wizard
(see “USB Conguration” on page 17). To continue with this procedure, exit
the wizard: Use the arrow keys on the Installer Remote to select Exit from
the Welcome screen and press OK. In the conrmation pop-up window,
select OK, and then press OK once more on the Installer Remote.
Then, go to step 3.
• Otherwise, ensure the Target TV is in Pass-through Mode, and then
continue with step 2.
2. Use the Installer Remote to access the Target TV Installer Menu (see
“Accessing the Installer Menu” on page 20 for further information). Set
Installer Menu item 117 FACT DEFAULT to 1, and press OK. When the
value changes back to 0, press OK again to exit the Installer Menu.
Note: This step restores factory default settings on the TV.
3. Tune/set the TV to an analog or digital channel or Aux input (ideally the same
source tuned for 2-5-5 + MENU Mode during the Master TV Setup procedure).
4. Insert the USB memory device with the .tll le into the Target TV USB IN
port.
5. Press MENU SETTINGS on the Installer Remote to display the TV setup
menus. Use the arrow navigation keys to select/highlight the Option menu
icon, and then press the number “7” key a total of seven times to display the
USB Download Menu.
6. Use the Up/Down arrow keys to select Teach To TV (TLL), and then press
OK.
7. Use the Up/Down arrow keys to select the Master TV Setup you want to
install, and then press OK. Note: Filenames identify the TV, the TLX
version, and, in the case of the 60LP645H model, the chassis size.
Teaching status will be shown on a progress bar in a new window. When the
Teaching process is complete, the USB Download menu will reappear on
the screen.
8. When Teaching is done, press on the Installer Remote to exit the USB
Download Menu, remove the USB memory device from the Target TV, and
turn OFF the TV.
9. After a few seconds, turn ON the TV, and verify that the Master TV Setup is
now resident on the Target TV.
Note: When you turn it back ON, the TV will tune according to the setting of
Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start Channel is
specified, the TV will tune to that channel; otherwise, the TV will return to the
last channel tuned.
USB Cloning Procedures (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Previous OK
Teach To TV (TLL)
Previous OK
xxLP645H-UA00001.TLL
UPDATING...
Do not remove the USB from the port!
Do not unplug!
50%
Teach To TV