LG Electronics 42LD345H CRT Television User Manual


 
10
206-4186
Installer Remote Control Typical Key Functions
MENU
MUTE
VOL
CH
P
A
G
E
RETURN
INPUT
TV
ALARM
TIMER
1 2 3
4 5 6
7 8
0
9
FLASHBK
PORTAL
ENTER
GUIDE
EXIT
INFO
EJECT
SAP
RATIO
CC
i
NUMBER Buttons (0 - 9) & DASH
Use to enter a program number or channel.
Dash is used for sub-channel numbers such
as 2-1, 2-2, 9-1, 9-2, 100-3, 100-4, etc.
FLASHBK (FLASHBACK)
Returns to the previously tuned channel.
The LG Installer Remote is supplied with and dedicated to operate the TV. The LG Installer Remote illustrated below
and throughout this document shows typical remote control functions and is provided for reference only. This
Installer Remote may vary from the Installer Remote supplied with the TV.
Color buttons access special functions
in some menus.
USB BUTTONS
Use to view/navigate USB memory
device content.
EJECT
Ejects a USB memory device.
VOLUME UP/DOWN
Increases/decreases sound level.
INFO
Displays channel information.
PORTAL
Displays and removes the interactive
menu.
MUTE
Switches sound ON or OFF.
CHANNEL/PAGE UP/DOWN
Changes the channel. Moves from
one full set of screen information to
the next.
Arrows (Up/Down/Left/Right) & ENTER
Use to navigate on-screen menus and
adjust TV settings to your requirements.
MENU
Displays the TV setup menus on the screen.
Also exits the on-screen menu system and
returns to TV viewing.
GUIDE
Displays and removes the electronic
program guide.
CC
Press to activate subtitles.
RETURN
Returns one level to the previous menu/
display.
SAP
Analog Mode: Selects MTS sound (Mono,
Stereo, or SAP). DTV Mode: Changes
audio language, if additional languages are
available. *
EXIT
Clears all on-screen displays and returns to
TV viewing.
POWER
Turns TV ON or OFF.
ALARM
Sets the time when the TV
will automatically turn itself ON.
TIMER
Sets the amount of time before the TV
automatically turns itself OFF.
INPUT
Selects RGB, HDMI/DVI1, HDMI2,
Component Input, AV1, and AV2 sources.
TV
Returns to the last TV channel
(from an Aux input).
SAP notes:
If SAP is selected and no SAP is provided, sound
may not be heard on channel.
Each analog channel may have its own SAP setting.
Digital channels will reset to default audio language
with a power off/on.
*
RATIO
Adjusts the picture aspect ratio.