Filter
Top Products
122 Plasma TV
External Control Device Setup
26. Channel Add/Del (Command: m b)
G To add and delete the channels
Transmission
Data 0: Channel Delete
1: Channel Add
[m][b][ ][Set ID][ ][Data][Cr]
[b][ ][Set ID][ ][OK/NG][Data][x]
Acknowledgement
27. Key (Command: m c)
G To send IR remote key code
Transmission
Data Key code: Refer to page 124.
[m][c][ ][Set ID][ ][Data][Cr]
[c][ ][Set ID][ ][OK/NG][Data][x]
Acknowledgement
* All data are transmitted by Hexadecimal code
*Two/One part Channel: 6
th
bit
This bit is used in a cable-ready system.
*Using physical channel: 5
th bit
If the channel band is NTSC air or NTSC cable, channel tun-
ing can be done by only physical channel. In this case, using
physical channel bit must be low(0).
But if the channel band is ATSC air or ATSC cable, there are
two cases that physical channel enable or disable.
If the physical channel sending is meaningful, you should set
this bit low(0). If the physical channel sending is meaningless,
you should set this bit high(1).
Example)
1. Analog channel: NTSC cable, channel number(35), main
picture Command: ma 00 23 xx xx xx xx 01 attribute(0x01):
main picture, two part(it’s not mandatory), using physical chan-
nel, NTSC cable ‘xx’ data: don’t care major and minor channel
number in case analog channel tuning.
2. Digital channel: ATSC air, channel number(don’t know phys-
ical channel, major(30), minor(3)), sub picture
Command: ma 00 xx 00 1E 00 03 A2 attribute(0xA2): sub pic-
ture, two part, not using physical channel, ATSC air ‘xx’ data:
don’t care analog channel number in case digital channel tun-
ing.
3. Digital channel: ATSC air, channel
number(physical(20),major(20), minor(3)), sub picture
Command: ma 00 14 00 14 00 03 82
attribute(0x82): sub picture, two part, using physical channel,
ATSC air.
[a][ ][Set ID][ ][OK][Data0][Data1][Data2][Data3][Data4][x]
[a][ ][Set ID][ ][NG][Data0][x]
Acknowledgement
28. Input select(Command: x b) (Main Picture Input)
G To select input source for TV.
T
ransmission
[x][b][][Set ID][][Data][Cr]
[b][ ][Set ID][ ][OK/NG][Data][x]
Acknowledgement
Data Structure
DATA(Hex)
INPUT
00
DTV (Antenna)
01
10
11
20
21
40
41
50
60
90
91
DTV (Cable)
Analog (Antenna)
Analog (Cable)
Video
Front Video
Component 1
Component 2
RGB DTV
RGB PC
HDMI1/DVI
HDMI2
29. PIP Input Select(Command: x y)
G To adjust input source for sub picture in PIP mode
Transmission
[x][y][][Set ID][][Data][Cr]
Data Structure
DATA(Hex)
INPUT
00
DTV (Antenna)
01
10
11
20
21
DTV (Cable)
Analog (Antenna)
Analog (Cable)
Video
Front Video
[y][][Set ID][][OK/NG][Data][x]
Acknowledgement