Filter
Top Products
20
[LANGUAGE] Menu
Display Menu
Select a language for the Setup menu and on-
screen display.
Disc Menu / Disc Audio / Disc Subtitle
Select the language you prefer for the audio track
(disc audio), subtitles, and the disc menu.
[Original] – Refers to the original language in
which the disc was recorded.
[Other] – Press ENTER to select another lan-
guage. Use number buttons then ENTER to
enter the corresponding 4-digit number accord-
ing to the language code list on page 37.
[Off] (for Disc Subtitle) – Turn off Subtitle.
Note:
Depending on a disc, your language setting may not
be worked for some disc.
[AUDIO] Menu
Each disc has a variety of audio output options. Set
the player’s Audio options according to the type of
audio system you use.
Note:
Since many factors affect the type of audio output,
see “The unit’s Audio Output Specifications” on page
40 for details.
HDMI / SPDIF (Digital Audio Output)
Select the output sound format when a device
equipped with an HDMI or Digital Audio input jack is
connected to the HDMI OUT or DIGITAL AUDIO
OUT jack on this player.
[PCM Stereo] – Select if you connect this unit’s
HDMI OUT or DIGITAL AUDIO OUT jack to a
device with two-channel digital stereo decoder.
[PCM Multi-Ch] (HDMI only) – Select if you
connect this unit’s HDMI OUT jack to a device
with multi-channel digital decoder.
[DTS Re-Encode] – Select if you connect this
unit’s HDMI OUT or DIGITAL AUDIO OUT jack to
a device with DTS decoder.
[Primary Pass-Thru] – Select if you connect this
unit’s DIGITAL AUDIO OUT and HDMI OUT jack
to a device with LPCM, Dolby Digital, Dolby
Digital Plus, Dolby TrueHD, DTS and DTS-HD.
Notes:
• When [HDMI] option is set to [PCM Multi-CH], the
audio may output as PCM Stereo if the PCM
Multi-Ch information is not detected from HDMI
device with EDID.
• When [HDMI] and [SPDIF] options are set to
[DTS Re-Encode], the DTS audio will output on
BD-ROM disc, and the original audio will output on
the other discs (like [Primary Pass-Thru]).
Sampling Freq. (Maximum Sampling Frequency)
[192KHz] – Select this if your A/V Receiver or
Amplifier is capable of handling 192 KHz signals.
[96KHz] – Select this if your A/V Receiver or
Amplifier is NOT capable of handling 192 KHz
signals. When this choice is made, this unit auto-
matically converts any 192 KHz signals to
96 KHz so your system can decode them.
[48KHz] – Select this if your A/V Receiver or
Amplifier is NOT capable of handling 192 KHz
and 96 KHz signal. When this choice is made,
this unit automatically converts any 192 KHz and
96 KHz signals to 48 KHz so your system can
decode them.
Check the documentation for your A/V Receiver or
Amplifier to verify its capabilities.
DRC (Dynamic Range Control)
During the disc encoded in Dolby Digital or Dolby
Digital Plus is playing back, you may wish to com-
press the dynamic range of the audio output (the dif-
ference between the loudest sounds and the qui-
etest ones). This allows you to listen to a movie at a
lower volume without losing clarity of sound. Set
DRC to [On] for this effect.
Note:
The DRC setting can be changed only when a disc
is not inserted or the unit is in complete stop mode.