Filter
Top Products
Operation Reference Introduction
11
Installation and Setup
Audio Connection to Optional
Equipment
Connect the unit to your optional equipment for audio
output.
Amplifier equipped with 2-channel analog stereo
or Dolby Pro Logic ll / Pro Logic: Connect the left
and right AUDIO OUT jacks on the unit to the audio
left and right IN jacks on your amplifier, receiver, or
stereo system, using the audio cables (A).
Amplifier equipped with 2-channel digital stereo
(PCM) or audio / video receiver equipped with a
multi-channel decoder (Dolby Digital™, MPEG 2,
or DTS):
Connect one of the unit DIGITAL AUDIO OUT jacks
(OPTICAL O or COAXIAL X) to the corresponding
jack on your amplifier. Use an optional digital
(OPTICAL O or COAXIAL X) audio cable.
Digital Multi-channel sound
A digital multi-channel connection provides the best
sound quality. For this you need a multi-channel audio
/ video receiver that supports one or more of the
audio formats supported by your unit such as MPEG
2, Dolby Digital and DTS. Check the receiver manual
and the logos on the front of the receiver.
Notes:
• If the audio format of the digital output does not match
the capabilities of your receiver, the receiver produces
a strong, distorted sound or no sound at all.
• Six Channel Digital Surround Sound via a digital
connection can only be obtained if your receiver is
equipped with a Digital Multi-channel decoder.
Manufactured under license from Dolby
Laboratories. “Dolby”, “Pro Logic” and
the double-D symbol are trademarks of
Dolby Laboratories.
DTS and DTS Digital Out are trademarks
of Digital Theater Systems, Inc.