Filter
Top Products
Operation Reference Introduction
9
Installation and Setup
Setting up the Player
The picture and sound of a nearby TV, VCR, or radio
may be distorted during playback. If this occurs,
position the player away from the TV, VCR, or radio, or
turn off the unit after removing the disc.
DVD Player Connections
Depending on your TV and other equipment there are
various ways you can connect the player. Please refer to
the manuals of your TV, stereo system or other devices
as necessary for additional connection information.
Video and Audio Connections
to Your TV
Make sure the unit is connected directly to the TV and
not to a VCR, otherwise the DVD image could be
distorted by the copy protection system.
S-Video – Connect the S-VIDEO OUT jack on the
unit to the S-Video in jack on the TV using the S-
Video cable (S).
Video – Connect the VIDEO OUT jack on the unit
to the video in jack on the TV using the video cable
(V).
Audio – Connect the left and right AUDIO OUT
jacks of the unit to the audio left and right IN jacks
on the TV using the audio cables (A).
Do not connect the unit AUDIO OUT jack to the
phone in jack (record deck) of your audio system.
Component Video – Connect the COMPONENT /
PROGRESSIVE SCAN jacks on the unit to the
corresponding jacks on the TV using an Y P
B PR
cable (C).
Resolution setting
1. Press RESOLUTION once. The current resolution
setting will appear on the display window.
2. Press RESOLUTION repeatedly to change the
resolution you want.
The available resolution according to the connections
are as shown below.
Notes:
• The resolution of the VIDEO and S-VIDEO OUTPUT
is fixed to 480i.
• If your TV does not accept your resolution setting,
abnormal picture appears on the screen.
Please read TV’s owner’s manual then set the
resolution that your TV can accept.
• For 720p, 1080i and 1080p resolution on the
component video out, only non-copy protected discs
can be played back. If the disc is copy protected, it
will be displayed at the 480p resolution.
• Depending on your TV, certain HDMI output
resolutions may not work.
• Only resolutions supported by the TV are available.
Progressive Scan
• If your television is a high-definition or “digital ready”
television, you may take advantage of the unit
progressive scan output for the highest possible
video resolution.
•
Progressive scan does not work with the analog video
connections (yellow VIDEO OUT and
S-Video jack).
• The 1080p, 720p and 480p resolutions are the
progressive scan applied resolution.
Note for 1080p resolution
This unit is able to provide a 1080p full HD image to
most 1080p-capable TVs in the market today.
However, there are some 1080p TVs available from
certain companies that are limited in the types of
1080p images that can be accepted. Specifically,
1080p-capable TVs that don’t accept images in 60Hz
can't display an image from this unit.
Installation and Setup
OUTPUT CONNECTION
Available Resolution
HDMI
VIDEO OUT
COMPONENT
VIDEO OUT
VIDEO OUT
1920 x 1080p
1920 x 1080i
1280 x 720p
720 x 480p
720 x 480i
1920 x 1080p
1920 x 1080i
1280 x 720p
720 x 480p
720 x 480i
720 x 480i
S-VIDEO
720 x 480i