Filter
Top Products
Appendix
87
Appendix
6
*5 If the [HDMI] or [Digital Output] option is set
to [DTS re-encode], the audio output is limited
to 48 kHz and 5.1Ch. If the [HDMI] or [Digital
Output] option is set to [DTS re-encode], the
DTS Re-encode audio is output for BD-ROM
discs, and the original audio is output for the
other discs (like [Primary Pass-Thru]).
y
If [HDMI] option is set to [PCM Multi-CH] and
[Digital Output] option is set to [Primary Pass-
Thru], it plays Dolby Digital Plus.
y
If the HDMI connection is version 1.3 and Dolby
Digital Plus/Dolby TrueHD is output from HDMI
OUT jack.
y
The audio is outputted as PCM 48 kHz/
16 bit for MP3/WMA le and PCM
44.1 kHz/16 bit for Audio CD while playback.
y
The Dolby TrueHD audio recorded on some Blu-
ray discs consists of Dolby Digital and TrueHD
audio. Dolby Digital audio is output through
DIGITAL AUDIO OUT jacks and “DD” displays on
the screen if TrueHD audio is not output (for
example, when [HDMI] is set to [PCM Stereo] and
[Digital Output] is set to [Primary Pass-Thru]).
y
You must select a digital audio output and
a maximum sampling frequency that your
Amplier (or AV receiver) accepts using [Digital
Output], [HDMI] and [Sampling Freq.] options on
the [Setup] menu (see page 33-34).
y
With digital audio connection (DIGITAL AUDIO
OUT or HDMI), Disc Menu button sounds of BD-
ROM may not be heard if the [Digital Output] or
[HDMI] option is set to [Primary Pass-Thru].
y
If the audio format of the digital output does
not match the capabilities of your receiver, the
receiver will produce a strong, distorted sound
or no sound at all.
y
Multi-channel Digital Surround Sound via digital
connection can only be obtained if your receiver
is equipped with a Digital Multi-channel decoder.
About the internal
hard disk drive
The internal hard disk drive (HDD) is a fragile piece
of equipment. Please use the player following the
guidelines below to protect against possible HDD
failure.
y
Do not move the player while it is on.
y
Install and use a player on a stable, levelled
surface.
y
Do not use the player in excessively hot or
humid places, or in places that may be subject
to sudden changes in temperature. Sudden
changes in temperature can cause condensation
to form inside the player. This can be a cause of
HDD failure.
y
While the player is powered on, do not unplug
from the wall socket or switch the electricity o
from the breaker switch.
y
Do not move the player immediately after
switching it o. If you need to move the player,
please follow the steps below:
1. After the message “OFF” is shown in the
display, wait at least two minutes.
2. Unplug from the wall socket.
3. Move the player.
y
If there’s a power failure while the player is on,
there is a chance that some data on the HDD will
be lost.
y
The HDD is very delicate. If used improperly or
in an unsuitable environment, it is possible that
the HDD will fail after a few years of use. Signs
of problems include playback unexpectedly
freezing and noticeable block noise (mosaic) in
the picture.
y
However, sometimes there will be no warning
signs of HDD failure.
y
If the HDD fails, playback of content will not
be possible. In this case, contact the LG service
center by following methods.
Web: http://lgservice.com
y
The manufacturer disclaims responsibility for loss
of data contained in internal HDD.
y
There are some capacities in HDD reserved for
the le system and timeshift.