Filter
Top Products
- 20
Daily operation
Adjusting the sound
Switching sound off/on
Sound off;
Sound on: Press button again or set volume V+.
Setting the volume
V+/V– Volume louder / quieter.
The volume bar will be shown briefly if no other menu
is displayed.
Setting the sound mode
Call Sound mode.
34 Select the number of speakers you want to hear.
Additional sound settings for volume adjustment and for Sound mode:
➠ As long as you can still see the volume bar or the
selection of speakers for sound mode:
Call additional sound settings.
34 Select sound setting,
6 go to the menu line below.
34 Make changes.
Sound settings via the TV menu
➠ In normal TV mode, without other displays.
Call TV menu.
34 Select Sound,
6go to the menu line below.
34 Select desired sound setting,
6 go to the menu line below.
34 Make changes.
Explanations of the sound settings:
Select the number of speakers you want to hear. The
selection depends on the connected sound components
(from page 47) and on the transmitted audio signal.
➠ If the number of speakers appears in brackets, the
sound of missing speakers is transmitted by the existing
speakers (virtual).
The momentarily reproduced audio signal is output with
the ideal number of speakers.
Play centre sound or mono (left/right).
Play front sound (L/R stereo).
Play front and centre sound.
Play front and surround sound.
Play front, surround and centre sound.
Play via an external HiFi amplifier. Selection is only possible
if an amplifier has been selected in the sound components
wizard (see page 52).
Speech, Classical, Pop, Custom music, and Custom film
sound.
Adjust the headphones volume.
Proper boost of bass and treble tones at low volume.
Here you can make Dolby Pro Logic II sound settings for
movie, music, matrix and personal settings. Menu item
only appears with certain sound mode settings.
Call with OK.
Selection possibility Mono/Stereo or Sound 1 or Sound
2 for two-sound broadcasts separately for speakers and
headphones. Only available for analogue stations.
Reduces volume differences, e.g. for advertisements that
are too loud.
Sound selection for two-sound broadcasts.
Determining the maximum volume that can be set.
Specify the volume that is set when switching on the TV
set with the mains switch.
If the volume when switching off the TV set into standby
mode is higher than specified here, it is automatically
reduced to the fixed switch-on volume when switching
back on.
The volume can differ according to the individual stations.
If the sound is too loud or too quiet in relation to other
stations, adjust the volume. When the menu is open, you
can select the stations one after another with P+/P– and
adjust every single station conveniently.
Set stereo balance so that the volume impression is identical
on the left and right.
Sound mode
optimal
1
2
3
4
5
Amplifier
Sound
adjustment
Headphone vol.
Loudness
Dolby PLII
mode
more ...
Loudspeaker/
Headphone
sound
Auto Volume
AV output
signal
Maximum
volume
Switch on
volume
Volume
adjustment for
current station
Balance
END
Sound adjustmentVolume
Sound mode DPLII mode
24
Headphone volume
4
Sound mode ...
(5)
optimal
3 2 1