Filter
Top Products
51 -
Operating additional equipment
OK continue to set the
Distance to left front speaker.
➠ Measure the distances from your listening position to
the front, surround, and centre speakers respectively.
The Dolby Digital decoder calculates the delay times
for the speaker signals from these so that they reach
the listener simultaneously.
34Set the distance between the left front speaker
and your listening position in 10 cm steps.
OK Continue respectively to the other speakers and
34 adjust the distance.
➠ After setting the distance for the centre speaker ...
OK Continue to Adjust speaker level.
34 Adjust the volume for each speaker.
6 Select speakers manually.
➠
For balanced audio reproduction all speakers should
be set at the same volume level. A noise signal will be
reproduced automatically on each speaker in succes-
sion.
Adjust every speaker to equal perceived volume
from your listening position
.
OK Continue to Subwoofer phase.
Switch to a station with music with P+/P– or start playback
with music on a DVD player.
34Test both values (0º and 180º) and select the one
with which you get a clearer bass reproduction
from your listening position.
OK to confirm the setting and exit the wizard.
This ends the sound components wizard for connecting
and setting up a speakers system.
END
OK
Proceed
Distance to left front speaker
4,2 m
Sound components
Sound components wizard
Please enter the distance of the left front
speaker from your listening position here.
4,2m 4,0m
1,0m 0,9m
2,7m
0dB 0dB
0dB 0dB
END
OK
Adjust speaker level
0 dB
Sound components
Sound components wizard
You hear a sound from every speaker one after
another. But you can also select the speakers
manually with the menu control buttons up/down.
Set the volume for the respectively active speaker
shown in blue so that you get approximately the
same volume impression from all the speakers.
Proceed Preceding/next loudspeaker
END
OK
0°
Subwoofer phase
Sound components
Sound components wizard
Here you can reverse the phase of your subwoofer. Test both values in music
reproduction and then select the one with which you get a better bass
reproduction.
180°
Proceed