Filter
Top Products
+ Level
will increase the dim-
ming level (%) of the
fixture from 0–100%.
■ The level can be increased one
percent at a time by clicking the but-
ton singly.
■ Holding the button down,
will gradually increase the fixture
to 100%.
■ The longer the +Level button is held,
the faster dimming will occur.
Note:
Due to the nature of dimmable
ballast’s, the Lowel Fluo-Tec dimmable
studio fixtures begin their dimming lev-
els at 1%, to prevent flicker at lower
levels. You can set the fixture
to dim all the way to 0%, but that will
then require lamps to ‘start up’ before
full dimming up can occur.
– Level
will decrease
the dimming level (%)
of the fixture from
100%–0.
■ The level can be decreased
one percent at a time by clicking
the button singly.
■ Holding the button down,
will gradually decrease the fixture
to 0%.
■ The longer the–Level button is held,
the faster dimming will occur.
–Address
will change
the address of
the fixture that is
being accessed,
descending
from 512–1.
■ The + Address button advances
one at a time by clicking the
button singly.
■ Holding the button down,
will gradually scroll through
the addresses.
■ The longer the button is held,
the faster it will scroll.
■ After unit 512 is reached,
the remote control will return
to unit 1.
+ Address
will change the
address of the
fixture that is
being accessed
from 1–512.
■ The –Address button advances one
at a time by clicking the button
singly.
■ Holding the button down,
will gradually scroll downward
through the addresses.
■ The longer the button is held,
the faster it will scroll.
■ After unit 1 is reached,
the remote control will return
to unit 512.
Note:
See MODE sub-menu #5 (pg.4)
for more information on setting the
number of channels to be controlled.
5
Buttons/Arrows
SET
a multifunction button.
Transmitting Pre-stored
Levels
■ When pressed, the IR DMX
Controller updates (retransmits) all
512 channel levels to their previously
set levels, as saved in the remote’s
internal, non-volatile memory.
If the IR Sensor did not receive
any part of the infrared beam while
transmitting dimming commands
(ex. – something blocking the line of
sight between the Controller and the
IR Sensor unit), the dimmable fixture
will be set to a different level than is
displayed in the IR DMX Controller
LCD. By pressing the SET button,
all values will be retransmitted,
“re-synchronizing” the dimming
levels of the fixtures to the displayed
level in the IR DMX Controller.
Note:
Pressing SET while sending val-
ues will interrupt transmission.
If one or more dimmable fixtures were
turned off (i.e. at night, or for lamp
change), their dimming levels will be
different than what has been saved in
the IR DMX Controller’s memory.
Pressing the SET button, updates all
the fixtures to their desired levels
simultaneously.
Saving Scenes
■ A secondary function of the SET
button is to save Scenes. See pg. 7
for more information.
Shutting Down
■ To turn the IR DMX Controller
OFF, hold the SET button
for 2 seconds.
Buttons