Filter
Top Products
6
Using The IR DMX Controller
Important -
To use the IR DMX Controller,
fluorescent fixtures must first
be ‘enabled’.
See Sub-Menu Mode, pg 4.
LCD
2 line, 8 character Liquid
Crystal Display.
Once turned ON, the Left side
displays the DMX-512 Address channel
being accessed (1–512) or ALL
(in which case up to 512 fixtures will be
accessed simultaneously). The Right
side displays the dimming level
(0–100%) of the unit corresponding
to that address.
In addition, an asterisk will also be
displayed in the center of the lower line
when the MODE button has been
pressed, to indicate an instant ON
(level of 100%) or an instant OFF
(level of 0%) capability, upon pressing
the +LEVEL or –LEVEL. Otherwise,
the unit will dim up or down when the
LEVEL buttons are pushed.
Note:
a flashing “dot” in place of the
asterisk =
low battery.
LCD
(Liquid Crystal Display)
Buttons
Familiarize yourself with the location of the control buttons. Some buttons control more than one function.
Read pages 4-5 for more information.
+Level
Will increase the dimming level (%) of
the fixture from 0-100%.
–Level
Will decrease the dimming level (%)
of the fixture from 100%–0.
+Address
Will change the address of the fixture
that is being accessed from 1–512.
ALL This is a toggle function.
MODE
This is a multifunction button.
ON
Quickly press to turn the unit ON.
SET
This is a multifunction button.
–Address
Will change the address
of the fixture that is being accessed,
descending from 512–1.