Magnavox 26MD301B Flat Panel Television User Manual


 
16
WATCHING TV
Sleep Timer
can set the unit to go into standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes).
Sleep 120min.
Press SLEEP once to call up the display for checking the remaining time.
To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is
displayed.
Switching Each Input Mode can easily switch with the remote control
between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press SOURCE or CH + repeatedly to cycle through the input modes.
e.g.) 32MD311B/32MD301B/26MD311B/26MD301B
Source
TV
Video
Component
HDMI1
HDMI2
Video Component
11.1
DTV / TV channel
HDMI2 HDMI1
(or PC input)
• Pressing CH reverses the direction of the input modes.
*
These may differ depending on what product you purchased. For example, 22MD311B,
19MD311B or 19MD301B will be displayed [HDMI1], [HDMI2] and [PC] instead.
Freeze Mode can freeze the image shown on the TV screen for 5 minutes.
Press FREEZE to freeze the image.
Freeze
The sound output will not be paused.
To cancel freeze mode, press any buttons except .
Channel Selection
Select channels by using CH + / or the Number buttons.
To select the memorized channels,
use CH + / or the Number buttons.
To select the non-memorized channels,
use the Number buttons.
11.1
To use the Number buttons
AT SC
- When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
NTSC
- When selecting cable or analog channel 11
Press PREV CH to return to the previously viewed channel.
Note
[No Signal] will appear on the TV screen after the subchannel
broadcast is over.
[Audio only program] message will appear on the TV screen, when you
receive only sound signal.