Magnavox 26MD301B Flat Panel Television User Manual


 
8
Supplied Accessories
Owner’s Manual Quick Start Guide
Installation
EN
Installation
FR
Instalación
ES
If you have any questions, please visit our website at
www.
Best
Better
Good
magnavox.com/support
Quick
Start
Registration card
Remote Control
(NF801UD)
Batteries
(AAA, 1.5V x 2)
AAA
AAA
TV base and screws
Screws packed with this unit:
Model Quantity Size
32MD311B
4 M4 x 20
32MD301B
26MD311B
26MD301B
22MD311B
3 M4 x 1219MD311B
19MD301B
Note
If you lose the screws, please purchase the above-mentioned
Phillips head screws at your local store.
If you need to replace these accessories, please refer to the part
name and No. with the illustrations and call our toll free customer
support line found on the cover of this manual.
When using a universal remote control to operate this unit.
Make sure the component code on your universal remote control
is set to our brand. Refer to the manual accompanying your
remote control for more details.
We do not guarantee 100% interoperability with all universal
remote controls.
Symbols Used in this Manual
The following is the description for the symbols used in this
manual. Description refers to:
TV FUNCTIONS
AT SC
: Digital TV operation
NTSC
: Analog / Cable TV operation
If neither symbol appears, the operation is applicable to both.
DVD FUNCTIONS
DVD
: Playback of DVD-video
CD
: Playback of audio CD
If neither symbol appears under the function heading, operation is
applicable to both.
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction. At least 2 people are required for these steps.
1 Spread a thick and soft cloth over a table as shown at step 2.
Place the main unit face down onto it. Make sure not to
damage the screen.
2 Insert 2 hooks under the
bottom of the main unit
into base holes (shown by
arrow
), then move the
base in the direction as
shown by arrow
until it
stops and the screw holes
are aligned. Make sure not
FRONT
to put the AC power cord between the base and the unit.
3 Drive Phillips head screws
into the threaded holes
at the bottom of the base
until they are tight.
To remove the base from this unit
Unscrew the Phillips head screws in step 3.
After the screws are removed, move the base in the opposite direction
as shown by arrow in step 2, then pull the base up toward the rear of
the unit. Be careful not to drop the base when you remove it.
Note
When attaching the base, ensure that all screws are tightly fastened. If
the base is not properly attached, it could cause the unit to fall, resulting
in injuries as well as damage to the unit.
Make sure to use a table which can support the weight of this unit and
is larger than this unit.
Make sure the table is in a stable location.
When attaching the base, ensure that FRONT
written on the base is
upward. If it’s not upward, the 2 hooks don’t t in the base.