Filter
Top Products
IN
OUT
ANT.
ANT.
ANT.
ANT.
6 Hooking Up the TV/VCR
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT
Jack on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal or an anten-
na to the ANT(enna) Jack.
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
1
Hook up your TV/VCR using one of the connections shown.
A.
B.
Hooking Up Your TV/VCR With an
Indoor Antenna
To install a rod antenna (not supplied), push
the stem of the antenna into the antenna hole
on the top of the TV/VCR. Connect the
antenna wire to the ANT(enna) Jack on the
back of the TV/VCR as shown. Extend the
antenna and adjust its length, direction, and
angle for the clearest picture.
C.
Connect the Cable signal to the IN
Jack on the Cable Box.
ANT.
ANT.
Rod Antenna
(not supplied)
CCZ252comb.QX33 4/6/99 8:50 PM Page 6