Filter
Top Products
6 Hooking Up the TV/VCR
ANT.
IN
OUT
ANT.
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal
or an antenna to the
ANT(enna) Jack.
1
Hook up your TV/VCR using one of the connections shown.
ANT.
Rod Antenna
(not supplied)
Connect the Cable signal to
the IN Jack on the Cable Box.
RF coaxial cable
(not supplied)
A
Hooking Up Your
TV/VCR With a Cable
Signal or Outdoor
Antenna
B
Hooking Up Your
TV/VCR With a Cable
Box
To view any channel, set the
TV/VCR to the Cable Box
output channel (channel 03 or
04). Then, select channels at
the Cable Box.
C
Hooking Up Your
TV/VCR With an
Indoor Antenna
To install a rod antenna (not
supplied), push the stem of
the antenna into the antenna
hole on the top of the
TV/VCR. Connect the anten-
na wire to the ANT(enna)
Jack on the back of the
TV/VCR as shown. Extend the
antenna and adjust its length,
direction, and angle for the
clearest picture.
MC13D1MG 3/22/02 1:26 PM Page 6