Filter
Top Products
14 Hookups (cont’d)
Connecting to a TV and a Receiver
with and without Dolby Pro Logic decoding
1
Connect the supplied video cable to the yellow Video jack of the
DVD Player and to the TV’s Video In jack. The supplied video cable
has yellow markings.
2
Connect the supplied audio cable to the white and red Audio L/R
(left and right) jacks on the DVD Player and to the left/right Audio
In jacks on the Stereo. Match the cable colors to the jack colors.
3
Plug the power cords of the DVD Player, Stereo, and the TV into an
active power outlet. Press STANDBY-ON
yy
on the front of the
DVD Player to turn it on.
4
Turn on the Stereo and set it to the correct Audio In channel or
sound source. Refer to the Stereo owner’s manual for details.
5
Turn on the TV. Set it to the correct Video In channel. See your TV
owner’s manual for details. Or, go to your lowest TV channel (01 or
02) and change channels downward until you see the DVD screen
saver on the TV.
• If you prefer or need to use the
S-video or Y Pb/Cb Pr/Cr jacks
instead, see pages 12-13.You
only need one video connection
between the TV and the DVD
Player.
• Adjust Downmix and Dual
Mono accordingly. Details are
on page 36.
Helpful Hints
LEFT AUDIO IN
RIGHT AUDIO IN
Stereo
(example only)
Back of TV
(example only)
VIDEO IN
1
VIDEO IN
3
2
MDV455_17x 11/11/03 4:34 PM Page 14