Magnavox MDV455 DVD Player User Manual


 
Hookups (cont’d) 15
Connecting to a TV and a Stereo
(Stereo has Dolby Digital
TM
or MPEG2)
1
Connect the Coaxial jack of the DVD Player to the Coaxial Digital
Audio In jack on your Stereo. Use an appropriate digital audio cable
(not supplied). See your electronics retailer for details and
availability.
2
Connect the supplied video cable to the yellow Video jack of the
DVD Player and to the TV’s Vidio In jack. The supplied video cable
has yellow markings.
3
Plug the power cords of the DVD Player, Stereo, and the TV into an
active power outlet. Press STANDBY-ON
yy
on the front of the
DVD Player to turn it on.
4
Turn on the Stereo and set it to the correct Audio In channel or
sound source. Refer to the Stereo owner’s manual for details.
5
Turn on the TV. Set it to the correct Video In channel. See your TV
owner’s manual for details. Or, go to your lowest TV channel (01 or
02) and change channels downward until you see the DVD screen
saver on the TV.
Set SPDIF Output accordingly.
Details are on page 37.
•Your Stereo must support
MPEG2 or Dolby Digital.Check
the Stereo’s manual.
If you prefer or need to use the
S-VIDEO or Y Pb/Cb Pr/Cr jacks
instead, see pages 12-13.
Helpful Hints
Back of TV
(example only)
COAXIAL DIGITAL
AUDIO IN
2
1
Stereo Receiver
(example only)
VIDEO IN
VIDEO IN
3
MDV455_17x 11/11/03 4:34 PM Page 15