Marantz DV6001 DVD Player User Manual


 
6
DVD Setup Menu
39
English
DIGITAL OUT
Default setting: ALL
Set the Digital output according to your
optional audio equipment connection.
OFF – Turn off the digital output.
ALL – If you have connected your DIGITAL
AUDIO OUT to a multi-channel decoder/
receiver.
PCM ONLY – Only if your receiver is not
capable of decoding multi-channel audio.
Note
If HDMI is activated, DIGITAL OUT is muted. HDMI
audio out is related to the “DIGITAL OUT” setting.
If set the “ALL” is set, HDMI Audio out is follows the
EDID. If set the “PCM” is set, HDMI Audio out is
always PCM.
If you set to “ALL” with a non-DTS compatible
amplifi er, noise will be output when you play a DTS
disc.
LPCM OUT
Default setting: 48kHz
If you connect the DVD Player to a PCM
compatible receiver via digital terminals,
coaxial or optical, you may need to adjust
“LPCM Output”. Discs are recorded at
a certain sampling rate. The higher the
sampling rate, the better the sound quality.
48kHz – Playback a disc recorded at the
sampling rate of 48 kHz. A 96 kHz (if
available on disc) PCM data stream will be
converted to 48 kHz.
96kHz – Playback a disc recorded at the
sampling rate of 96 kHz. If the 96 kHz
disc is copy-protected, the digital output
will automatically be converted to a
sampling rate of 48 kHz.
Note
High sampling rate DVD-Audio discs (192 kHz or
17 6.4 kHz) always output audio that has been
down sampled to 96 kHz or 88.2 kHz through the
digital outputs, when LPCM OUT is set to 96 kHz.
HDMI AUDIO OUT
Default setting: AUTO
AUTO – In this mode, when discs
recorded in Dolby Digital, DTS, or MPEG
are played, the respective bit stream signal
is output. When DVD-Video/DVD-Audio
discs with multi-channel audio are played,
the multi-channel signal is output. When
discs recorded in 2-channel PCM or other
2-channel format are played, the audio
is output as 2-channel PCM. The output
formats are limited by the capabilities of
the connected component. For example,
if the disc is recorded in Dolby Digital
but the connected component does not
support Dolby Digital, the audio is output
as multi-channel PCM. If the con nect ed
component does not support multi-
channel PCM either, the audio is output
as 2-channel PCM.
Multi PCM – In this mode, when discs
recorded in Dolby Digital, DTS, MPEG,
or DVD-Video/DVD-Audio are played,
a multi-channel signal is output. When
discs recorded in 2-channel PCM or other
2-channel format are played, the audio
is output as 2-channel PCM. The output
formats are limited by the ca pa bil i ties of
the connected component. For example,
if the disc is recorded in Dolby Digital
but the connected component does not
support Dolby Digital, the audio is output
as 2-channel PCM.
2ch PCM – In this mode, audio is output
as 2-channel PCM for all discs. Select this
mode when the unit is connected to a TV
or projector.
Off – Audio signals are not output from
the HDMI jack.
Note
When audio signals are being output by HDMI-
compatible components, digital output signals are
muted.
If HDMI is activated, DIGITAL OUT is muted. HDMI
audio out is related to the “DIGITAL OUT” setting.
If set to “ALL”, HDMI Audio out is follows the EDID.
If set to “PCM”, HDMI Audio out is always PCM.
Audio is not output when the player is connected
to a device with an HDCP-compatible DVI jack.