Filter
Top Products
12
ENGLISH
SETUP
SETTING THE IR OUTPUT LEVEL
The DIP switches at the bottom of the RX3001 can be used to set the IR output levels from IR output
jacks 1 to 3 and IR output jacks 4 to 6.
Note:
The default setting is high output (LEVEL 4), and so
when the IR emitter is affi xed to a device, the output
level can be so high that remote commands cannot be
controlled properly.
Be sure to set the IR output level according to the status
of the connected device.
LEVEL
OUTPUT 4+5+6 OUTPUT 1+2+3
SW 1 SW 2 SW 3 SW 4
1 OFF OFF OFF OFF
2 OFF ON OFF ON
3 ON OFF ON OFF
4 ONONONON
SETTING THE CHANNEL
Use the CH selector knob to set to the same channel as the RC3001.
12
ID
4
3
2
1
ON OFF
CH selector knob
Notes:
• When setting the channel with the CH selector, the available channels are CH1 to CH4 with two setting
positions for each channel.
CH1 CH2 CH3 CH4
• The RC3001 default channel is channel 1.
• To change the channel of the remote controller, change the channel setting in the Wizz.it 3 editor.
1
2
3
4
5
6
12
I
D
4
3
2
1
O
N
O
FF
OUT6
OUT5
OUT4
OUT3
OUT2
OUT1
4
3
2
1
ON OFF