Filter
Top Products
User Guide
56
Frequently Asked Questions
WARNING Should you use the REVERT button, the only way to recover
the factory configuration is by using RCEdit and a Windows
PC.
Procedure for reverting to the memory saving REVERT file:
1 Navigate to the HOME panel.
2 Touch the Mode button.
The Mode Menu appears.
3 Touch the Setup button.
The first setup panel appears.
4 Scroll to the second setup panel.
5 Tap the Revert button.
6 Tap Revert to confirm the action.
Note The REVERT button is not active until at least one change is
made to the configuration (a label, a delay in a macro or one
new code has been learned). Should the button be greyed out,
make a change to the configuration and then use revert.
How do I calibrate the touchscreen?
The RC9200/5200 is calibrated when it leaves the factory, so
normally you do not have to calibrate it yourself. It is possible that
the RC9200/5200 displays a message to calibrate the touchscreen.
If this message appears do the following.
You will see the instruction “Touch TOP LEFT corner.”
1 Tap as close as possible the upper left corner using a blunt tip
of a pencil.
You will see the instruction “Touch BOTTOM RIGHT corner.”
2 Tap as close as possible the bottom right corner using a blunt tip
of a pencil.