6
With your computer turned off:
9. Place the Delta 44 break-out box on a desktop in a convenient but secure place,
or mount the unit in a 19” rack-mount chassis. Rack mounting may be
accomplished with a universal rack-mount tray, using a 5mm screw through the
tray and into the mounting hole on the bottom of the Delta 44 break-out box.
10. Connect one end of the supplied host cable to the 15-pin D-sub connector on the
break-out box.
11. Connect the other end of the host cable to the 15-pin D-sub connector on the
Delta 44 PCI Host card that now resides in your computer.
Delta Driver & Software Installation
The Delta 44 system includes a “Drivers CD” for Windows 98/95/NT and
Macintosh, containing all Windows drivers, Macintosh drivers (including all ASIO
drivers), and Delta Control Panel software. To install these on your system, please
follow these steps:
Windows 98 Installation
1. After installing the Delta 44 hardware, boot your system and start Windows.
During the Windows boot procedure, the new hardware will be automatically
detected by the ‘Add New Hardware Wizard’, as shown here. Click ‘Next>’.
2. The ‘Add New Hardware Wizard’ will now ask how to locate the driver.
“Search for the best driver for your device” is already selected. Click ‘Next>’.
3. Windows will give you a selection of locations to search. Make sure that only
“Choose a Path” is checked, or click on the check box to do so. Insert the Drivers
CD into your CD ROM drive. Type in the drive letter of your CD drive (we will
assume here that it is D:\) and the path to the Delta drivers, which will be
D:\DeltaSeries\Delta9X. Click ‘Next>’.
4. The ‘Wizard’ reports that its Windows driver file search has found the M Audio
Delta 44. Click ‘Next>’.