Filter
Top Products
20
CHANNEL +/–
Press and release CH + or –. The
channel automatically stops at the next
channel set into memory.
For proper operation, before selecting
channels, they should be set into the
memory. See pages 22 and 23
“Memorizing channels”.
CALL
Press DISPLAY/CALL to display the
current information on the screen.
Press DISPLAY/CALL again to clear
the call display.
• Channel number or VIDEO mode
• Stereo or SAP (second audio
program) audio status
• Audio output status
QUICK VIEW
This button allows you to go back to
the last channel selected by pressing
QUICK VIEW. Press QUICK VIEW
again to return to the last channel you
were watching.
MUTE
Press MUTE to switch off the sound.
The
unit’s sound will be silenced and
“MUTE” will briefly appear on the
screen. The sound can be switched
back on by pressing this button again
or one of the VOL + or – buttons.
SLEEP
To set the unit to turn off after a
preset amount of time, press SLEEP
on the remote control. The clock will
count down 10 minutes for each
press of the SLEEP button (120, 110,
...10, 0). After the sleep time is
programmed, the display will appear
briefly every ten minutes to remind
you that the sleep timer is operating.
To confirm the sleep timer setting, press SLEEP and the remaining
time will be displayed for a few seconds. To cancel the sleep timer,
press SLEEP repeatedly until the display turns to 0.
SLEEP
120
MUTE
NOTE:
To listen through the headphones, insert
the plug to your headphones (not supplied)
equipped with a 1/8 inch mini plug into
the PHONES jack on the front of the unit.
The sound from the unit speaker is
muted.
CH 125
8 : 47
AM MON
TV/VCR
00 : 00 : 00 SP
STEREO SAP
TV operation
(continued)
5V40401A [En]18-21 2/3/06, 5:59 PM20