Filter
Top Products
44
Playback procedure
Reading
1
Press DVD to select DVD mode.
Press OPEN/CLOSE on the unit
or the remote control.
The disc tray will open.
2
Place a disc onto the tray.
Position it with the printed label
side up, align it with the guides,
and place it in its proper position.
3
Press OPEN/CLOSE or PLAY.
The disc tray closes automatically.
The TV-screen, “
” changes to
“Reading” and then playback
commences.
• A menu screen will appear on
the TV screen, if the disc has a
menu feature. In this case, press
, , , or ENTER to
operate a menu feature.
4
Press STOP to end playback.
• The unit memorizes the stopped point, depending on the
disc. “
” appears on the screen. Press PLAY to resume
playback (from the scene point).
• If you press STOP again or unload the disc (“
” appears
on the screen.), the unit will clear the stopped point.
5
Press OPEN/CLOSE.
The disc tray opens.
Remove the disc and press POWER.
The disc tray closes automatically and unit turns off.
NOTES:
• If a non-compatible disc is loaded,
“Incorrect Disc”, “Region Code Error” or
“Parental Error” will appear on the TV
screen according to the type of loaded
disc. If these appear, check your disc
again (see pages 42 and 55).
• Some discs may take a minute or so to
start playback.
• A “Prohibition” symbol “
” may
appear at the upper left of the screen.
This symbol means either the feature
you tried is not available on the disc, or
the unit cannot access the feature at
this time. This does not indicate a
problem with the unit.
• When you set a single-faced disc label
downwards (i.e. the wrong way up) and
press PLAY or OPEN/CLOSE on the
unit, “Reading” will appear on the
display for about 30 seconds and then
“Incorrect Disc” will be displayed.
• Some playback operations of DVDs
may be intentionally fixed by software
producers. Since this unit plays DVDs
according to the disc content recorded,
some playback features may not be
available. Also refer to the instructions
supplied with the DVDs.
5V40401A [En]42-46 2/3/06, 6:00 PM44