Filter
Top Products
42
Multiplexer function
You can display images captured by the connected cameras
on 4-split, 9-split, 10-split, 13-split or 16-split screen. In
addition, you can arrange the positions of the displayed
images on the screen.
Camera number buttons
DIGITAL ZOOM button
SPLIT buttons
Direction buttons
SEQUENCE button
OUTPUT A/B button
Notice
• You cannot switch the screen mode to the other single
screen modes or split screen mode while the menu
screen is displayed. To switch the screen mode,
close the menu screen fi rst and then press a camera
number button (1 to 16) or SPLIT button.
Single screen display
A live image captured by one camera is displayed on the
screen.
Step
1 Press a camera number button (1 to 16).
•
The image from the camera corresponding to the
button you pressed is displayed on the entire screen.
Split screen display
Images captured by multiple cameras are displayed on the
split screen.
Step
1 Press the SPLIT button.
Every time you press the button, the screen mode
changes in the order shown below.
4-split button (
): 4-split a 4-split b 4-split c
4-split d
4-split a ...
9-split button (
): 9-split a 9-split b 9-split a
...
10-split button (
): 10-split a 10-split b 10-split
a
...
13-split button (
): 13-split a 13-split b 13-split
a
...
16-split button (
): 16-split screen
Notice
• When the camera images are displayed in the split
screen mode, thin black bars may appear at the top
and bottom or right and left of respective images
depending on the types of the cameras you use. This
symptom tends to occur when the size of the camera
image is smaller than that defined by the display
specifi cations of this recorder.
Tips
• To set the camera numbers to be displayed in each
screen mode, use <Multiplexer setting> in the
<Setup> menu. You can set the camera numbers to
be displayed differently for Output A and Output B.
(
Page 110)
Sequential display
Images captured by cameras are displayed and switched at
constant intervals.
Step
1 Press the SEQUENCE button.
•
The sequential display starts in the currently selected
mode, split or single screen display mode.
•
Sequential display mode has the following types:
Single screen sequential display
4-split sequential display
9-split sequential display
10-split sequential display
13-split sequential display
Step
2 To cancel the sequential display, press the
SEQUENCE button again.
•
You can also cancel the sequential display by
displaying other type of split screen or by pressing
a camera number button (1 to 16) for single screen
display.
Notice
• Sequential display cannot be used during playback.
Tips
• To set the order of images to be displayed and the
switching interval, use <Multiplexer setting> in the
<Setup> menu. (
Page 110)
Viewing images captured by the cameras