Filter
Top Products
16 Display Module (FX3S-5DM)
154
FX3S Series Programmable Controllers
User's Manual - Hardware Edition
16.2 Installation and Removal
16.2.2 Installation and Removal
(when the expansion board/connector conversion adapter is used together)
The FX3S-30MT/ES is used as the main unit and the expansion board is used together in this example.
1 Attach the expansion board/connector conversion adapter to the main unit.
For the attachment method, refer to Chapter 7.
Caution
Make sure to attach the expansion board/connector conversion adapter before the display module.
2 Remove the upper connector cover (A in the
right figure).
3 Remove part B shown in the right figure using
a nipper, etc.
Caution
When part B is cut off, the display module can not be installed to
the main unit directly.
4 Attach the display module to the option
connector of the expansion board/connector
conversion adapter.
Make sure the display module is in parallel with the main
unit. Attach the display module to the option connector (C in
the figure on the right) of the expansion board/connector
conversion adapter as shown in the right figure (arrow 4).
Remove the display module as shown in the right figure
(arrow 4').
2
A
B
C
4
4'