Filter
Top Products
7 Installation In Enclosure
56
FX3S Series Programmable Controllers
User's Manual - Hardware Edition
7.3 Procedures for Installing on and Detaching from DIN Rail
7.3.3 Removal of main unit
Removal procedure
1 Open the terminal block cover, and remove the
lower terminal block cover (A in the right figure).
2 Disconnect the connecting cables (including
expansion board and special adapters).
3 Insert the tip of a flathead screwdriver into the
hole of the DIN rail mounting hook (B in the right
figure).
This step also applies for the DIN rail mounting hooks of the
special adapters.
4 Move the flathead screwdriver as shown in the
right figure to draw out the DIN rail mounting
hooks of all devices.
5 Remove the product from the DIN rail (C in the
right figure).
6 Push in the DIN rail mounting hooks (D in the
right figure).
A
C
B
3
4
5
6
D