Mitsubishi Electronics LT-37131 Flat Panel Television User Manual


 
Chapter 3. TV Operation 37
22
28
10
1
2
3
4
7
8
9
2423
26 27
25
16
17
11
12
13
14
15
5
6
18
19
20
21
Figure 1. Remote Control Overview
Battery Installation
1. Remove the remote control’s back cover by gently
pressing in the tab and lifting off the cover (Figure 2).
2.
Load the batteries, making sure the (+) and (-) polarities
are correct. For best results, insert the negative (-) end
first.
3. Snap the cover back in place.
Low Battery Indicator
If the
POWER
button blinks five times after you have pressed
any button, the remote control batteries are low and should
be replaced.
2
1
Figure 2. The remote control requires two AA alkaline
batteries.
Sleep Timer
Setting the Sleep Timer
1. Press
SLEEP
on the remote control.
2. Press
SLEEP
additional times to increase the time in 30-
minute increments up to the maximum of 120 minutes.
3. Press
EXIT
or wait five seconds without pressing any
buttons for the message to disappear.
4. Press
SLEEP
to view the time remaining before the sleep
timer turns off the TV.
Cancelling the Sleep Timer
1. Press
SLEEP
to display the on-screen message.
2. Press
SLEEP
repeatedly until OFF is displayed.
Note: After five seconds of inactivity, the message
box will disappear.
Care
For Best Results from the Remote Control:
Use only alkaline batteries.
Be within 20 feet of the equipment.
Do not press two or more buttons at the same time
unless instructed to do so.
Do not allow unit to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicals to clean. Use only a soft,
lightly moistened cloth.
Do not mix old and new batteries.
Do not heat, take apart, or throw batteries into fire.
Resetting the Remote Control
If the slide switch is set to
TV
and the TV does not respond
properly, do the following to reset the remote control.
1. Press and hold
POWER
for several seconds until the
button blinks twice and goes off.
2. Release the
POWER
button.
3. Press keys
0 0 9 3 5
. The
POWER
button will blink twice
when you finish entering the code.
Remote Control, continued