Filter
Top Products
9
MAN-PNLPC-001 MC200 Series Industrial Panel Computers
Installing the PANEL COMPUTER requires the following three major steps:
The Panel Computer is a front-panel stud mount unit. Mounting of the unit
requires a panel cutout, and drilling fourteen (14) holes in the mounting sur-
face for the mounting studs. Please see the Mounting section beginning on
page 10 for mounting diagrams and instructions.
Now that your Panel Computer is mounted, you are ready to connect your
unit to the power source, and peripheral devices. The Panel Computer’s
Serial Ports support one RS-232 COM1 and one RS-232/RS-422/RS-485
COM2 connector. (If RS-422 or RS-485 is required, refer to the PCA1675
Embedded Processor Board Manual, MAN-P1675-001.) The Parallel Port
supports SPP/EPP/ECP. The USB Port supports up to 2 ports (1.1). Note
that the Panel Computer is a 115/230 VAC powered unit. See the section on
External Components, beginning on page 14 for further information.
The Panel Computer has some adjustable features and tests. To change
any value, enter the SETUP MODE on powerup and follow the procedures
provided in the Communications Setup section beginning on page 19.
Mount the
Panel Computer
Make
Connections
Setup
INSTALLING THE INDUSTRIAL PANEL COMPUTER — OVERVIEW
4 INSTALLATION