Filter
Top Products
–
11
–
EN
1L25
HOOKUPS
FOR TVs WITH S-VIDEO INPUT JACK
Use an S-Video cable (commercially available) in place of the yellow video cable to enjoy pictures at higher quality.
CONNECTING TO A TV
OPTICALCOAXIAL
R
L
VIDEO
YCr
Cb S
SCAN MODE
VIDEO OUT
CENTER
SUBWOOFER
L
R
SURROUND
R
FRONT
L
ANALOG
5.1 CH
AUDIO OUT
IP
AUDIO OUT
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
To VIDEO OUT jack
To VIDEO INPUT jack
To Right (red)
and Left (white)
To AUDIO OUT jacks
AUDIO INPUT jacks
Notes
¡Connect the DVD player directly to a TV. If the A/V cables are connected to a VCR, pictures may be
distorted due to the copy protection system.
¡Be sure to turn off the power to all components in the system before connecting another component.
¡
Refer to the Owner's Manuals for your TV, stereo system and any other components to be connected to the DVD player.
¡The analog output terminal does not supply DTS sound.
OPTICALCOAXIAL
R
L
VIDEO
YCr
Cb S
SCAN MODE
VIDEO OUT
CENTER
SUBWOOFER
L
R
SURROUND
R
FRONT
L
ANALOG
5.1 CH
AUDIO OUT
IP
AUDIO OUT
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
To Right (red) and Left (white)
AUDIO OUT jacks
Stereo system
To VIDEO
INPUT jack
To VIDEO OUT jack
To S-VIDEO INPUT jack
To S-VIDEO OUT jack
but not both
To ANALOG AUDIO INPUT jacks
OPTICALCOAXIAL
R
L
VIDEO
YCr
Cb S
SCAN MODE
VIDEO OUT
CENTER
SUBWOOFER
L
R
SURROUND
R
FRONT
L
ANALOG
5.1 CH
AUDIO OUT
IP
AUDIO OUT
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
To S-VIDEO OUT jack
To S-VIDEO INPUT jack
To Right (red)
and Left (white)
AUDIO INPUT jacks
To AUDIO OUT jacks
[Fig. 1]
[Fig. 2]
[Fig. 3]
Selecting Progressive Scan (480p) or Interlaced (480i) Playback
¡If your TV is compatible with progressive scanning (480p), connect the TV to the Component Video Output
jacks of the DVD player and set the SCAN MODE switch on the back of the DVD player to “P”
(PROGRESSIVE). Next, set your TV to the progressive scan mode.
If your TV is not compatible with progressive scan, keep the SCAN MODE switch to “I” (INTERLACE).
¡Use a commercially available adaptor if the video input jacks of your TV or monitor are the BNC type.
¡When SCAN MODE switch is set to “P” (PROGRESSIVE), DVD player outputs from Component Video
Output Jack (not from VIDEO OUT or S-VIDEO OUT jack).
What is Progressive Scanning?
¡Unlike conventional interlace scanning, the progressive scan system provides less flickering and images in
higher resolution than that of traditional (480i) television signals.
¡
When P (PROGRESSIVE) is selected, no video signal will be output from the VIDEO OUT, or S-VIDEO OUT jack.
The DCDi (Directional Correlational De-interlacing) system of this DVD player produces smooth and natural video
images, even if really dynamic, by eliminating the jagged edges. "DCDi" is a trademark of Faroudja, a division of Genesis
Microchip Inc.
E5733UD.qxp 03.5.12 3:01 PM Page 11