Mitsubishi Electronics WS-55411 Projection Television User Manual


 
26
26
1
2
POWER
Code to enter:
To reset to default code, enter 000
Cable box brand
General Instruments/
Jerrold
Oak
Pioneer
Scientific Atlanta
Zenith
111, 119, 120, 121, 122,
123, 124, 125, 126, 127
102, 137, 139
101, 116
111, 112, 113
100, 117
If your
cable box
code is not
listed here,
please see
page 68
for a
complete
listing.
Cable Box Codes
3
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
Figure 3. Programming the remote to control your VCR.
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
VCR brand
Mitsubishi
Hitachi
JVC
Phillips / Magnavox
Panasonic
RCA
Sony
Toshiba
001, 002
020, 043, 065
030, 054, 059
043, 044, 051
041, 042, 043
020, 053, 065, 079
048, 049, 050, 074, 075
021,
If your
VCR
code is not
listed here,
please see
page 68
for a
complete
listing.
VCR Codes
3
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
Satellite brand
Mitsubishi DTV - DBS
Dishnetwork/Echostar
Hughes - DBS
RCA - DBS
Sony - DBS
Toshiba - DBS
Panasonic - DBS
006
175
173
176
177
170
174
If your
satellite
receiver
code is not
listed here,
please see
page 68
for a
complete
listing.
Satellite Receiver Codes
3
Figure 2. Programming the remote to control your
satellite receiver.
If you cannot turn the cable box ON by
pressing POWER, try pressing
CHANNEL or the number buttons.
When set to TV, the PLAY, STOP, REW/
REV, and FF/FWD buttons will operate
the VCR after the VCR codes have been
properly programmed into the remote
control.
Figure 1. Programming the remote to control your cable
box.
Use of the Remote Control with Other A/V Products
Use of the Remote Control with Other A/V Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(Figures 1-5)
1
Move the slide switch at the top of the
remote to the product you want to control.
2
Press and hold the POWER button on the
remote control.
3
Enter the rst three digit code listed for your
equipment, and then release the POWER
button on the remote control.
4
Point the remote control to the equipment
and press the POWER button.
Note: If the equipment responds, the remote
control is properly programmed to operate
the equipment. If the equipment does not
respond, repeat steps 2-4 with the next
three digit code listed in step 3 for your
equipment.