Mitsubishi Electronics WS-55411 Projection Television User Manual


 
27
27
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
DVD/LDP brand
Mitsubishi (DVD)
Mitsubishi (LDP)
Panasonic
Pioneer DVD (LDP)
Sony
Toshiba
Zenith
003
016, 017
250
252 (016, 017)
254
253
259
If your
DVD
code is not
listed here,
please see
page 68
for a
complete
listing.
DVD/LDP Player Codes
3
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
Audio brand
Mitsubishi A/V receiver
and/or CD player
Kenwood
Onkyo
Pioneer
Sony
Yamaha
Harman
Teac
010, 011
200, 208
209, 214,240
205, 207
222
201, 202
215
210
If your
audio
code is not
listed here,
please see
page 68
for a
complete
listing.
A/V Receiver Codes
3
If the slide switch is set to TV when you
enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
Figure 5. Programming the remote to control your A/V
receiver.
Figure 4. Programming the remote to control your DVD/
LDP.
Use of the Remote Control with Other A/V Products
After entering the correct codes in each
position of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If you
enter a code from the AUDIO chart while the
slide switch is set to TV, the volume and mute
functions change to match the A/V receiver.
This is useful when using an A/V receiver with
the TV all the time. In all other cases, only
one of the below devices is allowed for each
slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the
audio position may be used in conjunction
with select Mitsubishi CD players. Your audio
position must be programmed to either 010
or 011. Plug the CD player power cord into
a switched outlet on the back of your A/V
receiver. Pressing the POWER button turns
On the A/V receiver, along with the CD player.
In the audio position, for some CD players,
the transport controls (FF, Play, Rew, etc.)
operate the CD player.
Use of the Remote Control with Other A/V Products
Part lll: Setup