Mitsubishi Electronics WS-55411 Projection Television User Manual


 
71
71
Follow the steps below to install and remove the
Diamond Shield™
INSTALLATION
Note: Included in the Diamond Shield™
package are the following items:
(1) Diamond Shield™
(2) Molding Clips
1
Carefully remove the Diamond Shield™ from its
protective packaging. Wipe off any dust with a lint-free
cloth.
2
Begin by inserting the shield, sliding it into the
channels, starting at one side. Gently bow the
Diamond Shield™ toward you and insert the other side
of the Diamond Shield™ into the oppositive channel.
3
Install the top and bottom molding clips by pressing
them into the opening starting at a corner. Do not
force the clip. The clip will slide into place. This
completes the Diamond Shield™ installation.
REMOVAL
To remove the Diamond Shield™,
reverse the order of the above procedure.
Diamond Shield™ Installation and Removal Procedure
(VS-50111, VS-60111, WS-55311, WS-55411, WS-65311, WS-65411, WS-73411)
Appendix E: Diamond Shield Instructions
2
3
Appendix E: Diamond Shield Installation and Removal