Filter
Top Products
13
13
2
1
4
6
5
3
COMPONENT
480i /480P/ 1080i
AUDIO -
RIGHT
LEFT /
(MONO
)
AUDIO -
DT V
(YPbPr/ GBRHV)
MONITOR
IN PU T
OUT
2
1
ANT- A
ANT-B
LOOP
OUT
480i / 480P /1080i
AUDIO-
RI GHT
AUD IO-
LE FT /
(MONO)
V ID EO
S-VIDEO
2
IR EMITTER REPEATER
Y
P r
Pb
V
H
Y
G
Pb
B
P r
R
TV Back Panel
Back Panel
1
Monitor Out
The Monitor Output sends the TV audio and video signals
(excluding component video or DTV video) to an A/V receiver or other equipment.
2
Inputs 1-2
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, laser disc player,
or other A/V device to the TV. With each input, you may connect to the S-VIDEO or VIDEO
terminal but not to both.
3
Antenna (ANT-A, LOOP OUT, and ANT-B)
ANT-A and ANT-B receive signals from VHF/UHF antennas or a cable system. LOOP OUT sends
the ANT-A signal out to another component, such as a cable box or VCR.
4
IR Emitter Repeater (System 4 Home Theater IR Control)
Connecting IR emitters here allow the TV to automatically change a digital A/V receiver’s input in a
home theater setup and pass IR commands to other A/V devices.
(Applicable for WS-55411, WS-65411 and WS-73411 only.)
5
DTV Input
This input is used to connect a DTV receiver and can be congured for HDTV component
(YPbPr), RGB sync on green, and RGB plus H&V. Please see Appendix B, page 67, for signal
compatibility.
6
Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video outputs, such
as a DVD player or Video Game System. Please see Appendix B, page 67, for signal compatibility.
(Models VS-50111 and VS-60111 [4:3] only include Component Input 1.)
1
2
3
ANT-A
ANT-B
LOOP
OUT
6
5
TV Rear Side Panel
Back Panel
Part ll: Installation