Filter
Top Products
18
19
DVD Player with Component Video
(Figure 9)
1.
Connect the Component Video cables from
(YCb Cr or Y PbPr) VIDEO OUT on the back of
the DVD player to COMPONENT (1 or 2) on the
TV back panel. The correct connections are:
A.
Y to Y
B.
Cb or Pb to Pb
C.
Cr or Pr to Pr
2.
Connect a set of audio cables from AUDIO OUT
on the back of the DVD player to COMPONENT
AUDIO Input (1 or 2) on the TV back panel.
• The red cable connects to the R (right)channel
• The white cable connects to the L (left) channel
Note: Some video game systems support DTV
resolutions via component connections.
Please refer to your video game console
Owner’s Guide for setup information.
Note: For optimal DVD playback performance,
Mitsubishi recommends using a progressive
scan DVD player, set to play in progressive
scan mode. You will also want to set your
player to display 16:9 widescreen. Please
refer to your DVD player’s Owner’s Guide.
Other S-Video Device
(Figure 10)
1.
Connect an S-Video cable from VIDEO OUT
on the device back panel to VIDEO INPUT-1 or
INPUT-2 on the TV back panel.
2.
Connect a set of audio cables from AUDIO OUT
on the device back panel to AUDIO INPUT-1 or
INPUT-2 on the TV back panel, matching the
input used in step 1.
• The red cable connects to the R (right) channel
• The white cable connects to the L (left) channel
If your S-Video Device is mono (non-stereo),
connect only the white (left) cable.
Figure 9. Connecting a DVD Player with Component
Video.
Figure 10. Connecting an S-Video Device.
Connecting a DVD Player or Other S-Video Device
Note: The TV back panel and connections shown here are for reference only and may vary by model.
See Appendix, page 65, for component
video signal compatibility information.
For digital audio connections, see your
DVD and A/V receiver Owner’s Guides.
Connecting a DVD Player or Other S-Video Device