Filter
Top Products
28
29
If the slide switch is set to TV when you enter
an A/V receiver code, VOLUME and MUTE will
control the A/V receiver rather than the TV. To
return volume and mute control to the TV, set
the slide switch to TV, press and hold POWER
and enter 000.
Figure 5. Programming the remote to control your
A/V receiver.
Use of the Remote Control with Other A/V Products,
continued
After entering the correct codes in each position of
the remote control, use the slide switch to select
which product will respond when an operational
button is pressed. If you enter a code from the
AUDIO chart while the slide switch is set to TV, the
volume and mute functions change to match the
A/V receiver. This is useful when using an A/V
receiver with the TV all the time. In all other cases,
only one of the below devices is allowed for each
slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio
position may be used in conjunction with select
Mitsubishi CD players. Your audio position must
be programmed to either 010 or 011. Plug the CD
player power cord into a switched outlet on the
back of your A/V receiver. Pressing the POWER
button turns On the A/V receiver, along with the CD
player. In the audio position, for some CD players,
the transport controls (FF, Play, Rew, etc.) operate
the CD player.
POWER
Code to enter:
To reset to default code, enter 000
Audio brand
Mitsubishi A/V receiver
and/or CD player
Denon
Harman Kardon
JVC
Kenwood
Marantz
Onkyo
Pioneer
Sony
Technics
Yamaha
010, 015, 011, 012,
013, 014
234, 235, 236, 245,
246, 359
215, 223, 242
233, 232
208, 200
224, 350
209, 214, 240, 247
205, 207
222, 249
218, 219, 221
202, 201, 243, 244
If your
audio
code is not
listed here,
please see
page 66
for a
complete
listing.
A/V Receiver Codes
1.
3.
2.
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR
Some manufacturers may change their
products, or they may use more than one
remote control system. If this is the case,
your remote control may not be able to
operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
Use of the Remote Control with Other A/V Products, continued