Mitsubishi Electronics WT - 42313 Projection Television User Manual


 
24
25
The remote control may return to its initial setting
when the batteries are changed. You may need to
reprogram.
POWER
INFO
PAUSE
REC
FF/FWDREW/REV PLAY
STOP
3
6
9
QV
VOLUME
GUIDE
EXCH
ENTER
CANCEL
MENU
V-CHIP
FORMAT
PIPCH
1
7
SQV
4
INPUT
SLEEP
VIDEO
AUDIO
MUTE
2
5
8
0
CHANNEL
ADJUST
PIPINPUT
PIP/POP
HOME
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
size AAA
batteries
A A A
A A A
Figure 2. Installing the batteries.
Figure 1. Remote Control Functions.
Operation
Installing the Batteries:
(Figure 2)
1. Remove the remote control’s back cover by gently
pressing the ridged tab in the direction of the arrow
and sliding off the cover.
2. Load the batteries, making sure the polarities (+)
and (-) are correct. For ease of installation, install
the negative (-) side first.
For Best Results from the Remote Control:
Be within 20 feet of the equipment.
Do not press two or more buttons at the same time
unless instructed to.
Do not allow to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicals to clean. Use only a
soft, lightly moistened cloth.
Do not mix new and old batteries.
Do not heat, take apart, or throw batteries into fire.
Use only AAA batteries.
Operating the Remote Control:
You can use the remote to control the TV, CABLE/
DBS/DTV, VCR, DVD, and AUDIO products.
Select the product you want to control by moving the
slide switch to the appropriate position. The remote
control has been preset to operate the TV and other
Mitsubishi products. To program the remote control
to operate other products, see Use of the Remote
Control with Other A/V Products, page .
Remote Control Functions: Care and Operation