Filter
Top Products
25
Introduction
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
CONNECTING TO A TV DIRECTLY
NOTE
75-Ohm video and audio cables are supplied with the T585. SCART and S-Video cables can be purchased from your local NAD retailer.
WARNING
Do not connect the Digital Audio Output of this DVD player to your receiver unless you are connecting the DIGITAL OUT jack of this DVD player
to an AV decoder that has the Dolby Digital or DTS decoding function. High volume sound may damage your hearing as well as the speakersf er
(Refer to Initial Setup Settings, Audio).
NOTES
• Refer to the owner’s manual of your receiver as well.
• Before you connect the T585 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before
making any connections.
• Depending on your Digital sound decoder, the decode rate may be 96 or 48K.
• The output sound of the T585 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the
speakers may be damaged by a sudden high volume sound.
• Turn off the receiver before you connect or disconnect the T585’s power cord. If you leave the receiver power on, the speakers may be damaged.
S-VIDEO of the T585 to the
S-Video of the TV
Composite VIDEO
OUT Jack of the T585
to the composite
video of the TV
SCART/RGB OUT Jack of the
T585 (EURO version) to the 21-
pin SCART of the TV
COMPONENT VIDEO
OUT Jacks of the T585
to the component video
of the TV
TV or monitor with
audio/video inputs
T585 Safety.qxd 3/23/2006 4:12 PM Page 25