Filter
Top Products
English-13
Controlling the module via LAN Control
This module can be controlled by connecting a personal computer via this module’s Ethernet port.
NOTE: This LAN control can not control the LCD monitor.
1. Connection
First turn off the power of the LCD monitor and the computer, then make connection with LAN cable.
NOTE: Use a category 5 or higher LAN cable.
2. Network Setting
Set the IP address of the module on the “Network Settings” OSD menu.
NOTE: Refer to the “OSD Controls” - “Network Settings” section of this manual for the IP address setting.
3. Operation
1) Access is gained to the HTTP server function
by starting the Web browser on the computer
via the network connected to the module, then
entering the following URL.
http://<the module’s IP address>
Example: When the IP address of the
module is “192.168.0.1”, the URL is
http://192.168.0.1
2) Click the button on the control panel of the
computer to execute the function or the setting.
NOTE: Refer to the “Basic Operation” section of this manual for the
function.
Example 1: Direct Channel Setting
Clicking numeric buttons
[1],[2],[3],[-],[4],[ENT] will change the channel to “123-4”.
Example 2: Current Channel Read
Clicking the [CURRENT CHANNEL] button will display the current channel number to the
Display Area.
DisplayArea