Filter
Top Products
Turning On the Power
1. Connect the power plug to a power outlet.
2. Connect the DC output plug of the adapter to
the DC input jack on the main unit.
3. Hold down the button on the main unit for
about 2 seconds.
• The power indicator turns on. The player can now
be used.
• In the standby mode (when the power indicator is lit
red), the power can also be turned on by pressing
the power button on the remote control unit.
Hint:
The included AC adapter is compatible with voltages of
100 to 240V, so you can use it on trips overseas.
Note that you need a converter plug (available in stores)
suited for the region in which you are travelling.
Press button to open the player case.
Press button to release the disc cover
lock, the disc cover will eject up.
Set the disc in place and press down on the
disc with your fingers near the center hole. A
click is heard.
NOTE:
Set the disc securely. Failure to set it
securely could result in damage.
Do not use cracked or warped discs. Doing
so could result in damage.
Set single-sided DVDs or CDs with he label
(printed) side facing upwards. For
double-sided DVDs, check the side carefully,
then load the disc securely (until a click is
heard)
With CDs or one-sided DVDs, you do not
have to worry about touching the label
(printed) side of the disc with your fingers.
Two-sided DVDs, however, have signals
recorded on both sides, so be careful not to
scratch them when removing them from the
player.
Press down disc cover until a click is heard.
Or further close the player case lock , a click
is also heard.
Playback Functions
1.
2.
3.
•
•
•
•
4.
Loading discs
1
2
3
3
Power adapter
A
B
C
A
1
2
3
1
2
A
B
C
A
C
25
26
3