Niles Audio MS-1 Universal Remote User Manual


 
Avoiding Electrical Interference
Avoid locating the MS-1 near any potential sources of electri-
cal or optical noise, such as light dimmers, florescent lighting
fixtures, low-voltage lights, and neon lights.
If you are installing the MS-1 near a television, keep it at least
6" away from the top, bottom or sides of the TV to avoid
interference. Avoid running the MS-1's cable on the top of
the TV, or near the back cabinet of the TV. This will help
reduce the possibility of interference.
DO NOT INSTALL THE MS-1 INTO ELECTRICAL BOXES WITH
110 VOLT DEVICES.
Some states or municipalities allow devices such as the MS-1
to be installed into the same electrical box as 110 volt
devices, provided a "low-voltage partition" is used between
the devices. We do not recommend this. The cable connect-
ed to the MS-1 can act as an "antenna" for electrical noise.
Locating the MS-1 cable too close to a light dimmer or
switch may interfere with the MS-1. If you must locate the
MS-1 near electrical devices, install it in a separate metal elec-
trical box, ground the box to the electrical system ground,
and route the MS-1 cable several feet away from all electrical
wiring.
5
M
INIATURE
I
NFRARED
S
ENSOR
"TECH TIP"
Do not install the
MS-1 next to a light
dimmer, or where it
will be exposed to
direct sunlight.