Niles Audio MSU250 Universal Remote User Manual


 
TINSTALLATION
TOOLS REQUIRED
• 1/8” (0.3cm) Standard Slotted Screwdriver
• Wire Stripper
INSTALLATION
Before you begin, make sure that the sensor/keypad cables, the flasher cables and the 12VDC
power supply cable will all reach the proposed location of the MSU250. Mark the cables with
labels describing where the cable originates (rather than which terminal on the MSU250 it should
connect). For proper installation, follow the steps outlined below in the correct order. If you dis-
cover a fault in the course of installation, go on to the Troubleshooting Guide before continuing with
the next installation step.
8
(CONTINUED ON NEXT PAGE)
To 12V DC Power
Supply Plugged into
an switched AC Outlet.
Typically found in
back of a receiver.
WS110 Sensor
MSU250 Sensor
Connection
Figure 6
MSU250
Installation
To Niles
IR Flasher
To unswitched
AC Outlet
MSU250