12
INSTALLATION (CONTINUED)
STEP 8 – RECONNECTING THE CONNECTION HUB
Reconnect the sensor plug, flashers and power supply as outlined in steps 2, 3 and 4 (Figure 11).
That’s it! Now you are ready to control your audio/video equipment from the room you chose.
NOTE: MAKE SURE THAT THE STRIPPED ENDS OF THE WIRE DO NOT COME IN CONTACT WITH ONE
ANOTHER OR ANY SURFACE OTHER THAN THE CONNECTOR.
NORMAL OPERATION
To control your audio/video components, simply aim your remote control at the table-top sensor.
If you are within range (and your remote control’s batteries are fresh), the LED on the sensor will
flash a bright blue color each time you press a button on the remote (Figure 12). If you are using
a remote control with macro capabilities (a single press of a button issues a string of commands),
allow sufficient time for all of the commands to execute.
Figure 12: System Operation