Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI
5
INSTALLATION (CONTINUED)
STEP 2 – CONNECTING THE SENSOR CABLE TO THE
CONNECTION HUB
Select four conductors of the supplied CAT 5 wire and strip approximately 1/4” of insulation from
the wire. Insert each wire into the appropriate hole on the removable connector plug (Figure 2),
and snap the locking tab down. To help you, the connector plug is keyed. Insert the smooth side of
the connector plug into the smooth side of the socket. Don’t force the scalloped side of the con-
nector plug into the smooth side of the socket.
To unswitched
AC Outlet
To Niles IR Flasher
MSU140
To 12VDC Power Supply
Plugged into an switched AC
Outlet. Typically found in back of
a receiver.
MSU140 Sensor Connection
TS110 Sensor
Figure 2: MSU140 Installation