Filter
Top Products
GB 8
Connecting the Mediamaster
Please note the following:
• In some block of flats, the roof-mounted aerial system includes
a filter and channel selector. If so, the aerial may not work with
the Mediamaster. Please consult the landlord.
• Many older roof-mounted aerials may only receive a limited
number of channels. As a result, digital channels transmitted
on higher frequencies are difficult or even impossible to re-
ceive. The problem can be solved by replacing the roof aerial.
• Some outdoor aerials are directed towards an analogue trans-
mitter. The aerial must be directed towards a digital TV trans-
mitter.
• It is not always advisable to position the aerial as high as pos-
sible. If problems arise, experiment with different aerial
heights.
2. Indoor and window mounted aerials
It is not advisable to use indoor or window mounted aerials, as
digital channels will be difficult or even impossible to receive.
Connecting to the TV aerial
You can connect the Mediamaster to the following type of aerials:
1. Standard outdoor aerial
Where possible, use an outdoor roof aerial intended for receiv-
ing UHF channels between 21 and 69.
General about connections
There are many different types of TV/VCR and other equipment
that you can connect to the Mediamaster.
In this manual you will see some of the most common ways to
connect your equipment.
If you have problems with your connections and need help, con-
tact your retailer or Nokia Support.
Connecting to the TV with SCART
• Remove the aerial lead from your TV and connect this to the
TV AERIAL input socket on the Mediamaster.
• Connect a SCART cable between the main SCART socket on
the TV and the TV SCART socket on the Mediamaster.
• Connect an RF cable from the TV/VCR output on the Media-
master to the RF input socket on the TV.
• Switch on your TV, plug in and switch on your Mediamaster.
You may need to select the AV ( SCART ) channel on your TV
to watch Digital TV. In some cases your TV will automatically
select this channel when the Mediamaster is switched on.
Note: The RF lead will need to be connected in order to watch
analogue channels ( your old 1,2,3,4,5 )
It is always advisable to consult your TV instruction book.
SCART
RF